[iyonix-support] Re: Flashed it now, but ...

In message <499c4be250.Bernard@xxxxxxxxxxxxxxxx>
          Bernard Veasey <bernard@xxxxxxxxxxxxxx> wrote:

  

In message <b8e94ae250.Orpheus@xxxxxxxxxxxxxxx>
          Alex Cessford <alex@xxxxxxxxxxxxxxx> wrote:
    

Ok, now flashed to 5.16.
      

All seems fine but small hiccup.
      

I have very carefully recorded all messages, etc, in case I need to
re-tell them. Hopefully I won't.
      

So, short version:
Task Manager Info now says 5.16
I am using a Digimate 19" flatscreen. The display is huge.
Checked Display Manager, results as follows:
    Colours:    256     (menu all greyed-out)
    Resolution: 640x480 (drop-down menu button doesn't respond)
    Frame Rate  Unknown (drop-down menu button doesn't respond)
      

I would say something in your !Boot.Choices.Boot.PreDesk
has gone wrong before it reaches: !Boot.Choices.Boot.PreDesk.Configure
Open the PreDesk folder and tell us what is there before 'Configure'.
    

Bernard
    

Bernard, I am so very grateful for your near-instant response. Thank 
you so much.
Ok, I've attached PreDesk. However, whilst being strictly 
non-technical, I think I might have spotted the problem. The last line 
reads:
| Put other things which need setting up here.
|RMEnsure UtilityModule 5.14 Run 
!Boot.Choices.Boot.PreDesk.Softload.go514
|End

So am I right that this instruction to run Softload.go514 should be 
deleted? I *did* ensure that I removed Softload itself from !Boot 
before I re-flashed.