Mine is marked '24'. Regards Ralph W. Lambrecht On 1/6/05 6:57 PM, "Richard Knoppow" <dickburk@xxxxxxxxxxxxx> wrote: > > ----- Original Message ----- > From: "DarkroomMagic" <info@xxxxxxxxxxxxxxxx> > To: "PureSilverNew" <pure-silver@xxxxxxxxxxxxx> > Sent: Thursday, January 06, 2005 9:45 AM > Subject: [pure-silver] Re: Ralph Lambrecht / EM10 enlarging > meter? > > >> I'll send you what I have directly. However, I'm not sure >> my calibration >> works for you. Every EM10 is a bit differently calibrated, >> the calibration >> number is on the bottom of most, but I don't know what it >> means. >> >> As Richard already stated, you need to calibrate the dial >> in stops. A stop >> is a density difference of 0.3 log. Paper contrast is >> defined in negative >> density ranges. For example grade 2 has a negative density >> range of 1.05, >> consequently, 3 1/2 stops. I'll send you a table of those >> too. >> >> >> >> >> >> Regards >> >> >> >> Ralph W. Lambrecht >> >> > The number on the bottom is a nominal setting for > Ilfochrome. The meter was originally designed for > Ilfo/Cibachrome printing. Mine is marked 28, I suspect that > most of them have this number. It is about right for Iford > and Kodak VC paper for about a 20 second exposure, at least > on my enlarger. I originally calibrated the dial to allow > using other times and stops and then realized I could use it > as a densitometer over its range of sensitivity. Its a very > useful meter despite being quite cheap. I think they are > still around $30 US. > > --- > Richard Knoppow > Los Angeles, CA, USA > dickburk@xxxxxxxxxxxxx > > ============================================================================== > =============================== > To unsubscribe from this list, go to www.freelists.org and logon to your > account (the same e-mail address and password you set-up when you subscribed,) > and unsubscribe from there. ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.