On 7 May 2006 Martin Wuerthner <lists@xxxxxxxxxxxxxxx> wrote: > In message <SFqsnKAPtcXEpwpN@xxxxxxxxxxxxxxxxxxx> > Peter derwent <egroup@xxxxxxxxxxxxxxxxxxx> wrote: > >> I have solved it finally and thanks to all the guys who gave me ideas to >> test, but particularly Ian Hamilton, (who finally pointed me in the >> right direction by getting me to test a complicated doc not written by >> me)!!! >> >> The solution is that the Iyonix does not like Fireworkz docs with an >> embedded "Draw" file at the top, even though I have used these docs for >> about 4 years on my RiscPC. > > If at all, then you this should read "Fireworkz32 does not like...". > It is very unlikely to have anything to do with the Iyonix as opposed > to the RiscPC, it is more likely a problem with the software you run, > i.e., Fireworkz32 as opposed to whatever version of Fireworkz you used > on your RiscPC. > > Secondly, I can print Fireworkz documents with an embedded Draw file > at the top without any problems on my Iyonix, so your generalization > is not correct. Maybe the very specific Draw file you were using was > causing problems. And/or is this maybe one of those problems solved by SpecialFX? With best wishes, Peter. -- Peter \ / \ Prestbury, Cheltenham, Glos. GL52 Anne \ / __ __ \ England. and / / \ | | |\ | / _ \ http://pnyoung.orpheusweb.co.uk family / \__/ \_/ | \| \__/ \______________ pnyoung@xxxxxxxxxxxxx --- To alter your preferences or leave the group, visit //www.freelists.org/list/iyonix-support Other info via //www.freelists.org/webpage/iyonix-support