Blimey Clif, 'Ow yer expect the bloody pump to work if it ain't assembled!!!! Jesse in warm Troy, TN > Hi Jesse, > > I will take a photo but it will be of the pump loosely assembled. As I have > never got the steam cylinder to work I have never totally put it all > together. > > Regards > > Clif > > > ----- Original Message ----- > From: "Jesse" <fernj1@xxxxxxxxxxx> > To: <modeleng@xxxxxxxxxxxxx> > Sent: Wednesday, September 26, 2012 5:35 PM > Subject: [modeleng] Re: Parts prices > > >> Clif, just for the heckofit, send me a photo of that Southworth pump. >> Never heard of one and would like to see a pic. Many thanks, >> >> Jesse fernj1@xxxxxxxxxxxx >>> Clif, >>> There was one of the full-size pumps that used a shuttle valve as you >>> described. >>> Not sure why yours doesnt work. >>> >>> Never having seen or played with one, I cant offer any suggestions >>> though. >>> >>> Alan >>> >>> >>> On 25/09/2012 17:57, Clifton wrote: >>>> Hi All, >>>> >>>> On Duplex pumps I have been building one of the Southworth steam feed >>>> pumps, >>>> the little 3" high one& it is driving me round the twist. >>>> >>>> On a full size pump it is usual to have a rocking arm to transpose the >>>> down >>>> motion at the end of the piston rods travel to an up motion of the steam >>>> slide valve to make it double acting. (& vice versa at the top of the >>>> stroke). This little beast uses a slide valve which via steam passages >>>> operates a shuttle valve which then moves the main steam valve in the >>>> opposite direction. >>>> As the whole pump is only 3" high you can imagine the size of the steam >>>> chest which has two slide valves& a shuttle valve in it. >>>> >>>> I have now spent about a week trying to get it to work including making >>>> three news sets of slide valves& a new port face. I have trued to slide >>>> valve faces& port face using engineers blue& as far as I can see it is >>>> perfect. >>>> >>>> But will it go, will it heck! >>>> >>>> I think a bit of redesign is going to happen to get a rocking arm in. >>>> >>>> Regards >>>> >>>> Clif >>>> >>> MODEL ENGINEERING DISCUSSION LIST. >>> >>> To UNSUBSCRIBE from this list, send a blank email to, >>> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject >>> line. >> MODEL ENGINEERING DISCUSSION LIST. >> >> To UNSUBSCRIBE from this list, send a blank email to, >> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject >> line. >> > MODEL ENGINEERING DISCUSSION LIST. > > To UNSUBSCRIBE from this list, send a blank email to, > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject > line. MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.