I've been out of town a lot and just catching up on all that
has transpired with this topic, so I need to back up a bit. I couldn't
figure out why there was embosser info with the BANA template, as I've
been very careful to not include that when I'm working on the "clean"
template. FYI: I typically keep 2 to 3 versions of 10.5 on my computer.
I have shipping/SR1, beta, and sometimes the autobuild set up in
different folders. When I went back to find out why the BANA template
had embosser info, I discovered that an embosser configuration in ANY
of the templates, in ANY of the various 10.5 I have on my computer,
affects ALL versions and ALL templates. Based on this, I'm finding it
impossible to set up a separate embosser configuration for a particular
template, as it immediately changes the templates AND Global settings.
I downloaded the 3/15 autobuild while I was out of town and have it on
my notebook, along with the shipping/SR1 and beta versions. After I
installed the autobuild, I started having problems with the earlier
versions. When I start SR1 or beta, I get a message:
Syntax error in emb.elt at or near line 551. Embossing disabled.
I click OK and DBT starts. Then I go to Global | Embosser Setup and I
get a Memory Low message (I've just turned on the computer).
I can start the autobuild version without a problem.
I know it probably is better to keep one issue per message, but this is
along the same line as the issue of the embosser configuration being
read across all versions. As I work on the BANA template (as a
different named template), it shows up in ALL versions of 10.5.
My purpose in keeping the various versions available is so I can go
back and compare how things may or may not have functioned. Obviously
that isn't the case here, and DBT is sharing info between
the versions.
I guess my question is ... is DBT supposed to be sharing this info
across the various versions? I do I ever really know then, if a problem
is from the current version I think I'm running vs. a problem that
stems from another version?
Susan
* * *
* This message is via list duxhelp at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to