He says the set has HV no filament voltage the tubes should have glowing filaments with the anode lead removed from splitter and put into a glass container. If NO filaments at this point IT'S not the splitter.Repair the Filament circuit. Country TV Ron Miller Inez, TX. 77968 ----- Original Message ----- From: "armando guerra" <birdie@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, February 20, 2004 5:35 PM Subject: [TechAssist] Re: Zenith B/S PVR5263RK > If you remove the lead coming off the flyback into the H.V. divider and you have high voltage there, then the divider\splitter is bad.Very common failure. > Mando > Birdie's TV & Electronics > Casa GRande, AZ > > TV Man wrote: > > > Unit has sound no picture. The filaments don't light up. I have HV coming out of the flyback. How do you check the HV on each tube? They seem to be sealed. I'm guessing the focus block is bad, but before I order one I wanted to get some input. Thanks, Dave > > TV Man > > Inverness, Fl. > > > > -------------------------------------------------------------------------- --- > > Lost Password: > > http://www.tech-assist.org and select "Login Problems?". > > Email Archives: > > //www.freelists.org/archives/techassist/ > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/