[TechAssist] Re: Zenith B/S PVR5263RK
- From: "al m" <ampm@xxxxxxx>
- To: <techassist@xxxxxxxxxxxxx>
- Date: Sun, 22 Feb 2004 18:00:10 -0500
it's on the sweep board.Did you take the small board out and resolder
everything?
Al Marquardt
ampm@xxxxxxx
Al Marquardt Electronic Repair
206 W Main
Girardville Pa. 17935
----- Original Message -----
From: "TV Man" <tvman@xxxxxxxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Sunday, February 22, 2004 4:26 PM
Subject: [TechAssist] Re: Zenith B/S PVR5263RK
> Is it on the sweep HV board or the other one. Dave
> TV Man
> Inverness, Fl.
> ----- Original Message -----
> From: "al m" <ampm@xxxxxxx>
> To: <techassist@xxxxxxxxxxxxx>
> Sent: Sunday, February 22, 2004 9:58 AM
> Subject: [TechAssist] Re: Zenith B/S PVR5263RK
>
>
> > I can scan the filament section, but it would be probably better to send
> the
> > board out $100.00 and you're done with a warranty.
> > Al Marquardt
> > ampm@xxxxxxx
> > Al Marquardt Electronic Repair
> > 206 W Main
> > Girardville Pa. 17935
> > ----- Original Message -----
> > From: "Ron Miller d.b.a. Country TV" <rlmbkm@xxxxxxxxxx>
> > To: <techassist@xxxxxxxxxxxxx>
> > Sent: Sunday, February 22, 2004 11:26 AM
> > Subject: [TechAssist] Re: Zenith B/S PVR5263RK
> >
> >
> > > That unit uses a 9-1302 series SMPS/HV module.
> > > Country TV
> > > Ron Miller
> > > Inez, TX. 77968
> > >
> > > ----- Original Message -----
> > > From: "TV Man" <tvman@xxxxxxxxxxxxxxx>
> > > To: <techassist@xxxxxxxxxxxxx>
> > > Sent: Sunday, February 22, 2004 1:15 PM
> > > Subject: [TechAssist] Re: Zenith B/S PVR5263RK
> > >
> > >
> > > > No I don't, Dave
> > > > TV Man
> > > > Inverness, Fl.
> > > > ----- Original Message -----
> > > > From: "Ron Miller d.b.a. Country TV" <rlmbkm@xxxxxxxxxx>
> > > > To: <techassist@xxxxxxxxxxxxx>
> > > > Sent: Sunday, February 22, 2004 7:02 AM
> > > > Subject: [TechAssist] Re: Zenith B/S PVR5263RK
> > > >
> > > >
> > > > > Do you have a O'scope like an Sencore SC-61 or eqv.?
> > > > > Country TV
> > > > > Ron Miller
> > > > > Inez, TX. 77968
> > > > >
> > > > > ----- Original Message -----
> > > > > From: "TV Man" <tvman@xxxxxxxxxxxxxxx>
> > > > > To: <techassist@xxxxxxxxxxxxx>
> > > > > Sent: Sunday, February 22, 2004 11:46 AM
> > > > > Subject: [TechAssist] Re: Zenith B/S PVR5263RK
> > > > >
> > > > >
> > > > > > Check R3243 is good resoldered stand up board on sweep module
> still
> > no
> > > > > > filaments with anode out of splitter I have HV. Can't check for
HV
> > on
> > > > CRTs
> > > > > > because there seal. If splitter is bad do you lose filaments?
> > Thanks,
> > > > Dave
> > > > > > TV Man
> > > > > > Inverness, Fl.
> > > > > > ----- Original Message -----
> > > > > > From: "Ron Miller d.b.a. Country TV" <rlmbkm@xxxxxxxxxx>
> > > > > > To: <techassist@xxxxxxxxxxxxx>
> > > > > > Sent: Friday, February 20, 2004 4:12 PM
> > > > > > Subject: [TechAssist] Re: Zenith B/S PVR5263RK
> > > > > >
> > > > > >
> > > > > > > He says the set has HV no filament voltage the tubes should
have
> > > > glowing
> > > > > > > filaments with the anode lead removed from splitter and put
into
> a
> > > > glass
> > > > > > > container.
> > > > > > > If NO filaments at this point IT'S not the splitter.Repair
the
> > > > Filament
> > > > > > > circuit.
> > > > > > > Country TV
> > > > > > > Ron Miller
> > > > > > > Inez, TX. 77968
> > > > > > >
> > > > > > > ----- Original Message -----
> > > > > > > From: "armando guerra" <birdie@xxxxxxxxxxxxx>
> > > > > > > To: <techassist@xxxxxxxxxxxxx>
> > > > > > > Sent: Friday, February 20, 2004 5:35 PM
> > > > > > > Subject: [TechAssist] Re: Zenith B/S PVR5263RK
> > > > > > >
> > > > > > >
> > > > > > > > If you remove the lead coming off the flyback into the H.V.
> > > divider
> > > > > and
> > > > > > > you have high voltage there, then the divider\splitter is
> bad.Very
> > > > > common
> > > > > > > failure.
> > > > > > > > Mando
> > > > > > > > Birdie's TV & Electronics
> > > > > > > > Casa GRande, AZ
> > > > > > > >
> > > > > > > > TV Man wrote:
> > > > > > > >
> > > > > > > > > Unit has sound no picture. The filaments don't light up. I
> > have
> > > HV
> > > > > > > coming out of the flyback. How do you check the HV on each
tube?
> > > They
> > > > > seem
> > > > > > > to be sealed. I'm guessing the focus block is bad, but before
I
> > > order
> > > > > one
> > > > > > I
> > > > > > > wanted to get some input. Thanks, Dave
> > > > > > > > > TV Man
> > > > > > > > > Inverness, Fl.
> > > > > > > > >
> > > > > > > >
> > > > > > >
> > > > > >
> > > > >
> > > >
> > >
> >
>
> --------------------------------------------------------------------------
> > > > > > > ---
> > > > > > > > > Lost Password:
> > > > > > > > > http://www.tech-assist.org and select "Login Problems?".
> > > > > > > > > Email Archives:
> > > > > > > > > //www.freelists.org/archives/techassist/
> > > > > > > >
> > > > > > > >
> > > > > > >
> > > > > >
> > > > >
> > > >
> > >
> >
>
> --------------------------------------------------------------------------
> > > > > > > ---
> > > > > > > > Lost Password:
> > > > > > > > http://www.tech-assist.org and select "Login Problems?".
> > > > > > > > Email Archives:
> > > > > > > > //www.freelists.org/archives/techassist/
> > > > > > > >
> > > > > > > >
> > > > > > >
> > > > > > >
> > > > > > >
> > > > > >
> > > > >
> > > >
> > >
> >
>
> --------------------------------------------------------------------------
> > > > > > ---
> > > > > > > Lost Password:
> > > > > > > http://www.tech-assist.org and select "Login Problems?".
> > > > > > > Email Archives:
> > > > > > > //www.freelists.org/archives/techassist/
> > > > > >
> > > > > >
> > > > >
> > > >
> > >
> >
>
> --------------------------------------------------------------------------
> > > > > ---
> > > > > > Lost Password:
> > > > > > http://www.tech-assist.org and select "Login Problems?".
> > > > > > Email Archives:
> > > > > > //www.freelists.org/archives/techassist/
> > > > > >
> > > > > >
> > > > >
> > > > >
> > > > >
> > > >
> > >
> >
>
> --------------------------------------------------------------------------
> > > > ---
> > > > > Lost Password:
> > > > > http://www.tech-assist.org and select "Login Problems?".
> > > > > Email Archives:
> > > > > //www.freelists.org/archives/techassist/
> > > >
> > > >
> > >
> >
>
> --------------------------------------------------------------------------
> > > ---
> > > > Lost Password:
> > > > http://www.tech-assist.org and select "Login Problems?".
> > > > Email Archives:
> > > > //www.freelists.org/archives/techassist/
> > > >
> > > >
> > >
> > >
> > >
> >
>
> --------------------------------------------------------------------------
> > ---
> > > Lost Password:
> > > http://www.tech-assist.org and select "Login Problems?".
> > > Email Archives:
> > > //www.freelists.org/archives/techassist/
> > >
> > >
> >
> >
> >
>
> --------------------------------------------------------------------------
> ---
> > Lost Password:
> > http://www.tech-assist.org and select "Login Problems?".
> > Email Archives:
> > //www.freelists.org/archives/techassist/
> >
>
>
> --------------------------------------------------------------------------
---
> Lost Password:
> http://www.tech-assist.org and select "Login Problems?".
> Email Archives:
> //www.freelists.org/archives/techassist/
>
-----------------------------------------------------------------------------
Lost Password:
http://www.tech-assist.org and select "Login Problems?".
Email Archives:
//www.freelists.org/archives/techassist/
Other related posts:
