Given the info provided it's the board not the splitter,no filament on these is common and simple to troubleshoot. It is most likely due to an open connection at connector 3B5, that is the one that gees between the daughter pbc and the crts9 ringed connection at plug.) Country TV Ron Miller Inez, TX. 77968 ----- Original Message ----- From: "TV Man" <tvman@xxxxxxxxxxxxxxx> To: "TV Tech Line" <techassist@xxxxxxxxxxxxx> Sent: Sunday, February 22, 2004 5:12 PM Subject: [TechAssist] Zenith B/S PVR5263RK > Let's start over. Set has HV to the CRTs but no Filaments. Checked R3243 it's good @ 110K ohms. Resoldered board that stands upright. If I take out the anode lead from the flyback I still have no filaments. At this point I'd like to just send the board out for repair but do not know what board can cause this. Is it the sweep/HV board or can the HV block be bad even though I have HV to the CRTs.Thanks for all the past help. Dave > TV Man > Inverness, Fl. > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/