The filiment voltage comes from the flyback, BUT the most likely cause is bad solder on the daughter board that is soldered to the sweep board. The filiment voltage goes through it on the way from the flyback to the tubes. Had one this week. Walter --- George <grndmstrg@xxxxxxxxxxxx> wrote: > First check for reason filaments are not lighting > up. > > George > Afana Electronics > Moreno Valley, CA > > ----- Original Message ----- > From: "TV Man" <tvman@xxxxxxxxxxxxxxx> > To: "TV Tech Line" <techassist@xxxxxxxxxxxxx> > Sent: Friday, February 20, 2004 5:26 PM > Subject: [TechAssist] Zenith B/S PVR5263RK > > > > Unit has sound no picture. The filaments don't > light up. I have HV coming > out of the flyback. How do you check the HV on > each tube? They seem to be > sealed. I'm guessing the focus block is bad, but > before I order one I wanted > to get some input. Thanks, Dave > > TV Man > > Inverness, Fl. > > > > > -------------------------------------------------------------------------- > --- > > Lost Password: > > http://www.tech-assist.org and select "Login > Problems?". > > Email Archives: > > //www.freelists.org/archives/techassist/ > > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login > Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ===== Walter Wood Future Tech Home Center 2786 Hwy. 43 N. Lawrenceburg Tn. 38464 931-829-3337 Fax 931-829-4044 mailto:wwood_38478@xxxxxxxxx __________________________________ Do you Yahoo!? Yahoo! Mail SpamGuard - Read only the mail you want. http://antispam.yahoo.com/tools ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/