[TechAssist] Re: Zenith B/S PVR5263RK
- From: "al m" <ampm@xxxxxxx>
- To: <techassist@xxxxxxxxxxxxx>
- Date: Sun, 22 Feb 2004 10:29:30 -0500
What's the module #?
Al Marquardt
ampm@xxxxxxx
Al Marquardt Electronic Repair
206 W Main
Girardville Pa. 17935
----- Original Message -----
From: "TV Man" <tvman@xxxxxxxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Sunday, February 22, 2004 12:57 PM
Subject: [TechAssist] Re: Zenith B/S PVR5263RK
> No. Dave
> TV Man
> Inverness, Fl.
> ----- Original Message -----
> From: "al m" <ampm@xxxxxxx>
> To: <techassist@xxxxxxxxxxxxx>
> Sent: Sunday, February 22, 2004 6:48 AM
> Subject: [TechAssist] Re: Zenith B/S PVR5263RK
>
>
> > Do you have a manual?
> > Al Marquardt
> > ampm@xxxxxxx
> > Al Marquardt Electronic Repair
> > 206 W Main
> > Girardville Pa. 17935
> > ----- Original Message -----
> > From: "TV Man" <tvman@xxxxxxxxxxxxxxx>
> > To: <techassist@xxxxxxxxxxxxx>
> > Sent: Sunday, February 22, 2004 12:46 PM
> > Subject: [TechAssist] Re: Zenith B/S PVR5263RK
> >
> >
> > > Check R3243 is good resoldered stand up board on sweep module still no
> > > filaments with anode out of splitter I have HV. Can't check for HV on
> CRTs
> > > because there seal. If splitter is bad do you lose filaments? Thanks,
> Dave
> > > TV Man
> > > Inverness, Fl.
> > > ----- Original Message -----
> > > From: "Ron Miller d.b.a. Country TV" <rlmbkm@xxxxxxxxxx>
> > > To: <techassist@xxxxxxxxxxxxx>
> > > Sent: Friday, February 20, 2004 4:12 PM
> > > Subject: [TechAssist] Re: Zenith B/S PVR5263RK
> > >
> > >
> > > > He says the set has HV no filament voltage the tubes should have
> glowing
> > > > filaments with the anode lead removed from splitter and put into a
> glass
> > > > container.
> > > > If NO filaments at this point IT'S not the splitter.Repair the
> Filament
> > > > circuit.
> > > > Country TV
> > > > Ron Miller
> > > > Inez, TX. 77968
> > > >
> > > > ----- Original Message -----
> > > > From: "armando guerra" <birdie@xxxxxxxxxxxxx>
> > > > To: <techassist@xxxxxxxxxxxxx>
> > > > Sent: Friday, February 20, 2004 5:35 PM
> > > > Subject: [TechAssist] Re: Zenith B/S PVR5263RK
> > > >
> > > >
> > > > > If you remove the lead coming off the flyback into the H.V.
divider
> > and
> > > > you have high voltage there, then the divider\splitter is bad.Very
> > common
> > > > failure.
> > > > > Mando
> > > > > Birdie's TV & Electronics
> > > > > Casa GRande, AZ
> > > > >
> > > > > TV Man wrote:
> > > > >
> > > > > > Unit has sound no picture. The filaments don't light up. I have
HV
> > > > coming out of the flyback. How do you check the HV on each tube?
They
> > seem
> > > > to be sealed. I'm guessing the focus block is bad, but before I
order
> > one
> > > I
> > > > wanted to get some input. Thanks, Dave
> > > > > > TV Man
> > > > > > Inverness, Fl.
> > > > > >
> > > > >
> > > >
> > >
> >
>
> --------------------------------------------------------------------------
> > > > ---
> > > > > > Lost Password:
> > > > > > http://www.tech-assist.org and select "Login Problems?".
> > > > > > Email Archives:
> > > > > > //www.freelists.org/archives/techassist/
> > > > >
> > > > >
> > > >
> > >
> >
>
> --------------------------------------------------------------------------
> > > > ---
> > > > > Lost Password:
> > > > > http://www.tech-assist.org and select "Login Problems?".
> > > > > Email Archives:
> > > > > //www.freelists.org/archives/techassist/
> > > > >
> > > > >
> > > >
> > > >
> > > >
> > >
> >
>
> --------------------------------------------------------------------------
> > > ---
> > > > Lost Password:
> > > > http://www.tech-assist.org and select "Login Problems?".
> > > > Email Archives:
> > > > //www.freelists.org/archives/techassist/
> > >
> > >
> >
>
> --------------------------------------------------------------------------
> > ---
> > > Lost Password:
> > > http://www.tech-assist.org and select "Login Problems?".
> > > Email Archives:
> > > //www.freelists.org/archives/techassist/
> > >
> > >
> >
> >
> >
>
> --------------------------------------------------------------------------
> ---
> > Lost Password:
> > http://www.tech-assist.org and select "Login Problems?".
> > Email Archives:
> > //www.freelists.org/archives/techassist/
>
>
> --------------------------------------------------------------------------
---
> Lost Password:
> http://www.tech-assist.org and select "Login Problems?".
> Email Archives:
> //www.freelists.org/archives/techassist/
>
>
-----------------------------------------------------------------------------
Lost Password:
http://www.tech-assist.org and select "Login Problems?".
Email Archives:
//www.freelists.org/archives/techassist/
Other related posts:
