Dave, The large board that is soldered to the sweep, you need to remove and solder the connections...especially on the connector that has the wire bundle that goes to the CRT's. Those pins get cracked solder. It may be time consuming, but it's a profitable repair since no parts are involved. Jeff Dougherty Intrepid Video TV/VCR 263 S Front St Steelton PA 17113 fax...717-564-4952 www.intrepid-video.com www.tech-repair.net ----- Original Message ----- From: "TV Man" <tvman@xxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Sunday, February 22, 2004 4:26 PM Subject: [TechAssist] Re: Zenith B/S PVR5263RK Is it on the sweep HV board or the other one. Dave TV Man Inverness, Fl. ----- Original Message ----- From: "al m" <ampm@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Sunday, February 22, 2004 9:58 AM Subject: [TechAssist] Re: Zenith B/S PVR5263RK > I can scan the filament section, but it would be probably better to send the > board out $100.00 and you're done with a warranty. > Al Marquardt > ampm@xxxxxxx > Al Marquardt Electronic Repair > 206 W Main > Girardville Pa. 17935 > ----- Original Message ----- > From: "Ron Miller d.b.a. Country TV" <rlmbkm@xxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Sunday, February 22, 2004 11:26 AM > Subject: [TechAssist] Re: Zenith B/S PVR5263RK > > > > That unit uses a 9-1302 series SMPS/HV module. > > Country TV > > Ron Miller > > Inez, TX. 77968 > > > > ----- Original Message ----- > > From: "TV Man" <tvman@xxxxxxxxxxxxxxx> > > To: <techassist@xxxxxxxxxxxxx> > > Sent: Sunday, February 22, 2004 1:15 PM > > Subject: [TechAssist] Re: Zenith B/S PVR5263RK > > > > > > > No I don't, Dave > > > TV Man > > > Inverness, Fl. > > > ----- Original Message ----- > > > From: "Ron Miller d.b.a. Country TV" <rlmbkm@xxxxxxxxxx> > > > To: <techassist@xxxxxxxxxxxxx> > > > Sent: Sunday, February 22, 2004 7:02 AM > > > Subject: [TechAssist] Re: Zenith B/S PVR5263RK > > > > > > > > > > Do you have a O'scope like an Sencore SC-61 or eqv.? > > > > Country TV > > > > Ron Miller > > > > Inez, TX. 77968 > > > > > > > > ----- Original Message ----- > > > > From: "TV Man" <tvman@xxxxxxxxxxxxxxx> > > > > To: <techassist@xxxxxxxxxxxxx> > > > > Sent: Sunday, February 22, 2004 11:46 AM > > > > Subject: [TechAssist] Re: Zenith B/S PVR5263RK > > > > > > > > > > > > > Check R3243 is good resoldered stand up board on sweep module still > no > > > > > filaments with anode out of splitter I have HV. Can't check for HV > on > > > CRTs > > > > > because there seal. If splitter is bad do you lose filaments? > Thanks, > > > Dave > > > > > TV Man > > > > > Inverness, Fl. > > > > > ----- Original Message ----- > > > > > From: "Ron Miller d.b.a. Country TV" <rlmbkm@xxxxxxxxxx> > > > > > To: <techassist@xxxxxxxxxxxxx> > > > > > Sent: Friday, February 20, 2004 4:12 PM > > > > > Subject: [TechAssist] Re: Zenith B/S PVR5263RK > > > > > > > > > > > > > > > > He says the set has HV no filament voltage the tubes should have > > > glowing > > > > > > filaments with the anode lead removed from splitter and put into a > > > glass > > > > > > container. > > > > > > If NO filaments at this point IT'S not the splitter.Repair the > > > Filament > > > > > > circuit. > > > > > > Country TV > > > > > > Ron Miller > > > > > > Inez, TX. 77968 > > > > > > > > > > > > ----- Original Message ----- > > > > > > From: "armando guerra" <birdie@xxxxxxxxxxxxx> > > > > > > To: <techassist@xxxxxxxxxxxxx> > > > > > > Sent: Friday, February 20, 2004 5:35 PM > > > > > > Subject: [TechAssist] Re: Zenith B/S PVR5263RK > > > > > > > > > > > > > > > > > > > If you remove the lead coming off the flyback into the H.V. > > divider > > > > and > > > > > > you have high voltage there, then the divider\splitter is bad.Very > > > > common > > > > > > failure. > > > > > > > Mando > > > > > > > Birdie's TV & Electronics > > > > > > > Casa GRande, AZ > > > > > > > > > > > > > > TV Man wrote: > > > > > > > > > > > > > > > Unit has sound no picture. The filaments don't light up. I > have > > HV > > > > > > coming out of the flyback. How do you check the HV on each tube? > > They > > > > seem > > > > > > to be sealed. I'm guessing the focus block is bad, but before I > > order > > > > one > > > > > I > > > > > > wanted to get some input. Thanks, Dave > > > > > > > > TV Man > > > > > > > > Inverness, Fl. > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > -------------------------------------------------------------------------- > > > > > > --- > > > > > > > > Lost Password: > > > > > > > > http://www.tech-assist.org and select "Login Problems?". > > > > > > > > Email Archives: > > > > > > > > //www.freelists.org/archives/techassist/ > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > -------------------------------------------------------------------------- > > > > > > --- > > > > > > > Lost Password: > > > > > > > http://www.tech-assist.org and select "Login Problems?". > > > > > > > Email Archives: > > > > > > > //www.freelists.org/archives/techassist/ > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > -------------------------------------------------------------------------- > > > > > --- > > > > > > Lost Password: > > > > > > http://www.tech-assist.org and select "Login Problems?". > > > > > > Email Archives: > > > > > > //www.freelists.org/archives/techassist/ > > > > > > > > > > > > > > > > > > > > > -------------------------------------------------------------------------- > > > > --- > > > > > Lost Password: > > > > > http://www.tech-assist.org and select "Login Problems?". > > > > > Email Archives: > > > > > //www.freelists.org/archives/techassist/ > > > > > > > > > > > > > > > > > > > > > > > > > > > > > -------------------------------------------------------------------------- > > > --- > > > > Lost Password: > > > > http://www.tech-assist.org and select "Login Problems?". > > > > Email Archives: > > > > //www.freelists.org/archives/techassist/ > > > > > > > > > > -------------------------------------------------------------------------- > > --- > > > Lost Password: > > > http://www.tech-assist.org and select "Login Problems?". > > > Email Archives: > > > //www.freelists.org/archives/techassist/ > > > > > > > > > > > > > > -------------------------------------------------------------------------- > --- > > Lost Password: > > http://www.tech-assist.org and select "Login Problems?". > > Email Archives: > > //www.freelists.org/archives/techassist/ > > > > > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/