In message <a01016fc4e.martin@xxxxxxxxxxxxxxxxxxx> Martin Wuerthner <lists@xxxxxxxxxxxxxxx> wrote: > In message <4a1515fc4e.Colin@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx> > Colin Pritchard <colin.pritchard@xxxxxxxxxxxxx> wrote: > >> It is calling the printer StPhRX700fv: 1 > > Yes, I see that from your Settings file. That is not correct. > Something has corrupted the name. Actually, I just looked at your > settings file again and there is more corruption. Something has > inserted a printer definition in the middle of another. > >>>> There is the same error if I use Writer+. >>> >>> I assume that's a 32bit version. The error means there is insufficient >>> 'RMA' module area memory but this shouldn't really happen. What does >>> '*Status RMASize' say? If it's zero then try '*Configure RMASize 508K' >>> and reboot. >> >> I've done that too but I still get the same error message [see above]. >> Thinking I might reduce the quality of print in order to print >> anything at all, in accessing printer Control and click on Configure >> when I get the next error message >> Internal error 'StPhRX700fv: 1' won't fit icon 30 > > You could edit the Settings file to undo the corruption but I > recommend removing your printer definitions, choosing "Save choices", > reloading !Printers and creating a new definition from scratch. I've done that; the printer is now correctly named, but still gives me the same error about memory full. I can. now however, configure the printer control My settings now look like this fv: 1 cl: dp:2 nm: Epson Stylus Photo RX700** ct: 16_D bd: 16_75000004 ft: 16_4 et: fl: Devices#interface1;alternate0:USB44 ns: np: nu: no: uv: 16_4B8 up: 16_810 ua: 16_100 cf: 16_0 cs: 4 in: 8 nl: pt: g_mode:10 in: 261 fg: 16_43 pn: A4 paper size sn: StPhRX700 ic: gutenp_ij -- Colin ------------------------------------------------------------ To change, suspend or cancel your subscription go to //www.freelists.org/list/riscos-printing ------------------------------------------------------------