[riscos-printing] Re: New printer for Iyonix.
- From: Ian Hamilton <Ian_Hamilton@xxxxxxxxxxxxxxxx>
- To: riscos-printing@xxxxxxxxxxxxx
- Date: Sun, 01 Jul 2007 08:29:09 +0100
In article <809c38fb4e.Colin@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx>,
Colin Pritchard <colin.pritchard@xxxxxxxxxxxxx> wrote:
[Snip] Problems getting RX700 recognised.
The main problem is with the way you are connecting the printer to the
Iyonix because it isn't being recognised at all. Until this is sorted
neither printing or scanning will work. Try connecting the printer to one
of the Iyonix sockets rather than the USB hub.
> This is Settings
> fv: 1
> cl: dp:2
> nm: Epson Stylus Photo RX700**
> ct: 16_1 *************
> bd: 16_74000004
> ft: 16_4
> et:
> fl:
> ns:
> np:
> nu:
> no:
> uv: 16_0 *************
> up: 16_0 *************
[Snip]
You have two definitions set up. If you want to manually alter it (not
recommended) then change both sets to :-
ct: 16_D
uv: 16_4B8
up: 16_810
It would be better to fix the connection and run !PrtSet2USB (with the
printer switched on) because it still won't print until the Iyonix can
see the printer.
> USBKick states 'Complete - O.K.'. The RX700 works perfectly well from
> the PC laptop, printing and scanning !
This just confirms it's the cabling at fault.
HTH,
Ian
--
Ian Hamilton (RISC PC RO4) http://www.hamiltoni.pwp.blueyonder.co.uk/
(Iyonix RO5) Programs compatible with RISC OS 3/4/5
------------------------------------------------------------
To change, suspend or cancel your subscription go to
//www.freelists.org/list/riscos-printing
------------------------------------------------------------
Other related posts:
