In message <4a1515fc4e.Colin@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx> Colin Pritchard <colin.pritchard@xxxxxxxxxxxxx> wrote: > It is calling the printer StPhRX700fv: 1 Yes, I see that from your Settings file. That is not correct. Something has corrupted the name. Actually, I just looked at your settings file again and there is more corruption. Something has inserted a printer definition in the middle of another. >>> There is the same error if I use Writer+. >> >> I assume that's a 32bit version. The error means there is insufficient >> 'RMA' module area memory but this shouldn't really happen. What does >> '*Status RMASize' say? If it's zero then try '*Configure RMASize 508K' >> and reboot. > > I've done that too but I still get the same error message [see above]. > Thinking I might reduce the quality of print in order to print > anything at all, in accessing printer Control and click on Configure > when I get the next error message > Internal error 'StPhRX700fv: 1' won't fit icon 30 You could edit the Settings file to undo the corruption but I recommend removing your printer definitions, choosing "Save choices", reloading !Printers and creating a new definition from scratch. Martin -- --------------------------------------------------------------------- Martin Wuerthner MW Software lists@xxxxxxxxxxxxxxx --------------------------------------------------------------------- ------------------------------------------------------------ To change, suspend or cancel your subscription go to //www.freelists.org/list/riscos-printing ------------------------------------------------------------