Justin, I don't think you said which side of the paper looks yellow; face , back or both. Dave ----- Original Message ----- From: "Justin F. Knotzke" <jknotzke@xxxxxxxxx> To: <pure-silver@xxxxxxxxxxxxx> Sent: Tuesday, May 24, 2005 9:25 AM Subject: [pure-silver] Re: Yellow edges > On 5/23/05, Richard Knoppow <dickburk@xxxxxxxxxxxxx> wrote: > > > A couple of questions: First, how long after processing > > is the yellow stain appearing? It sounds like these are just > > done and coming out of the wash with the stain. > > Yes, as soon as they come out of the wash.. and even after they > come out of the fix they start to turn yellow. The RC isn't as bad as > the FB. The FB has to go into the trash. The RC just has it around the > edges. > > > Also, what kind of fixer are you using, type and brand? > > Ilford Rapid Fixer, 5L jug. > > > > Are you using a single or two bath system? > > Single. > > > Test the prints for residual silver by using Kodak Rapid > > Selenium Toner, diluted 1 part stock to 9 parts water. This > > similar to the sodium sulfide test but should be used only > > on well washed prints because it will fail if there is much > > hypo in the emulsion. Blot the surface moisture from the > > prints. Then place a couple of drops on a white area of the > > print (a border for instance) and allow to stand for about 3 > > minutes. Then rinse off. There should be NO visible stain. > > Any yellow or brown stain indicates unfixed halide in the > > emulsion. Note, this is a permanent stain so test on a print > > that can be discareded if it stains. If no stain shows, wash > > the print again as after toning. This is a better test than > > any test of the hypo itself because it shows if the hypo is > > working. > > Ok, thanks Richard. I will try this test next time I go into the darkroo= > m.=20 > > However, I have never had this problem before but I have never > forgotten to put stop in the stop bath. It might be a coincidence.. > Nevertheless, I will do the test but I am going to go out and get > another bottle of fixer. > > Oh I use Agfa Multicontrast paper developer and all my paper is Ilford.= > =20 > > J > > > --=20 > Justin F. Knotzke > jknotzke@xxxxxxxxx > http://www.shampoo.ca > ============================================================================ ================================= > To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there. > ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.