[argyllcms] Re: DTP20 Wont read 4x6 header strip

  • From: Bob Coss <bobcoss@xxxxxxxxx>
  • To: argyllcms@xxxxxxxxxxxxx
  • Date: Wed, 7 Sep 2011 11:31:06 -0400


I think your description of the DTP20 is appropriate.   I probably just
missed the fact that you can read it tethered without the TID.    So all is
good.   I'll send you a tiff file of the ColorElite TID when I get home

Thank you!


On Wed, Sep 7, 2011 at 10:28 AM, Graeme Gill <graeme@xxxxxxxxxxxxx> wrote:

> Bob Coss wrote:
> > The TID for a short chart created from the software that came with the
> DTP20
> > works fine for me on a 4x6, so I'm certain that it's capable.    I like
> your
> > charts because there are more patches per page on a 4x6 sheet.
> OK, this looks like a bug (the magenta patch at the end is missing). I
> wasn't properly allowing for the different patch length between the TID
> and the normal rows.
> > So I can skip reading the TID in tethered mode and start reading the
> chart
> > directly?    I didn't have a clue.  That might be a useful note to add to
> > your documentation for the DTP20 if you would for other folks.
> Yes. You just use it like any other strip meter. Plug it in and
> run "chartread basename". It will prompt you to start reading from
> strip A. Is there something I should add to
> <http://www.argyllcms.com/doc/instruments.html#DTP20> ?
> > Would you like to see the target file for the first page of a 4x6 so you
> can
> > see what a TID from ColorElite looks like?  That might help figure things
> > out.
> Sure, mail me a scan of the chart.
> Graeme Gill.

Hay que aprender algo nuevo todos los días

Other related posts: