Jesse We need a password. Lee ----- Original Message ----- From: <fernj1@xxxxxxxxxxxxx> To: <modeleng@xxxxxxxxxxxxx> Sent: Sunday, November 06, 2005 4:07 AM Subject: [modeleng] Re: Silversolder > OK Gents, the photograph of the great and outstanding silver solder tests with 7/32" dia 12L14 and 1018 steels can be seen at this site: http://photobucket.com/albums/c400/Unkajesse/?sc=1 if anyone is interested. The angle of bend that caused failure can be determined by the foreground 1018 butt joint. This angle was about the same for all four tests. Vise jaws were clamped about 1/4" from the joint and the rods were bent by hammering them to cause the bends. All of the broken surfaces looked alike,and though lighting causes some of them to appear different in the photo, rest assured that they all had a coating of solder on both sides of the break. > > Jesse the Tennessee redneck > -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.1.362 / Virus Database: 267.12.8/162 - Release Date: 5/11/05 MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.