Still unable to receive email on my exchange box. Changes made: Modified Relay Restrictions on Default SMTP Virtual Server to: Display IP address and 'Allow all except the list below' option. Anyone know of any whitepapers available for 'PROPERLY' setting up exchange to send and receive mail? Thanks -----Original Message----- From: Marvin Cummings [mailto:marvc@xxxxxxxxxxxxx] Sent: Tuesday, June 11, 2002 10:40 AM To: [ExchangeList] Subject: [exchangelist] RE: Help! http://www.MSExchange.org/ - Re-Vamped! Yes I had been receiving mail in the past. I had to 'unpublish' the server for a minute and after I 're-published' it again I started receiving this error. This was the same test message that I was using to test against my ISP email addy. I hadn't written any Recipient policies. I'm looking into that now. -----Original Message----- From: Lomker, Michael [mailto:mlomker@xxxxxxx] Sent: Tuesday, June 11, 2002 9:31 AM To: [ExchangeList] Subject: [exchangelist] RE: Help! http://www.MSExchange.org/ - Re-Vamped! > Recipient: <marvc@xxxxxxxxxxx> > Reason: 5.7.1 Unable to relay for marvc@xxxxxxxxxxx The server thinks that the message is spam (no-relaying). I'm assuming that you've received mail there in the past? If this is a new Exch2k server then you need to configure a Recipient Policy. If this is happening for just one e-mail address then you need to tell the server which IP addresses are permitted to send mail. The server thinks that the message is SPAM mail. Please provide more information about how the server is configured. ------------------------------------------------------ You are currently subscribed to this MSExchange.org Discussion List as: marvc@xxxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub') ------------------------------------------------------ You are currently subscribed to this MSExchange.org Discussion List as: marvc@xxxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub')