If you connect directly to the serial port on the processor you don't need a CAM. Regards, Kevin On Tue, Apr 27, 2010 at 5:25 AM, Donato Azevedo <donatoaz@xxxxxxxxx> wrote: > Gents, > > Is there a driver for the FBM230 that allows it to communicate with an > allen-bradley controller (PLC5) without the use of a 1770-KF2 protocol > converter? > > I found the EthernetIP FDSI driver for the FBM232/233 but I found no > other driver (for the FBM230). > > Regards, > -- > Donato Azevedo > > > _______________________________________________________________________ > This mailing list is neither sponsored nor endorsed by Invensys Process > Systems (formerly The Foxboro Company). Use the info you obtain here at > your own risks. Read http://www.thecassandraproject.org/disclaimer.html > > foxboro mailing list: //www.freelists.org/list/foxboro > to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join > to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave > > _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave