One other detail, the RED LED only does this slow steady flash, When it's connected to the 64. If it's just turned on, no lights Come on.... The green activity light does flash when the unit is accessible... (while the red led is off...) :) I may bring in my 64, sd2iec, etc next month ( if I don't get it sorted out ...) For repairs night... :) Cheers. -----Original Message----- From: torontocbm-bounce@xxxxxxxxxxxxx [mailto:torontocbm-bounce@xxxxxxxxxxxxx] On Behalf Of Miraglia, Walter Sent: Friday, May 22, 2009 3:53 PM To: torontocbm@xxxxxxxxxxxxx Subject: [torontocbm] Re: does any one know what the correct syntax for opening a .d64 image is on sd2iec? I'm having an issue with my SD2IEC board, Perhaps one of you guys have seen this... My LED1 ( the RED one ) slowly and steadily flashes... 2 seconds on two seconds off... while the red led is on, The unit is unavailable (device not present) however if I time A command correctly and send it while the RED led is off, I can access the unit... This is different from my syntax issue below... I'm just having one of those days.... So if anyone has seen this, and knows a cure? Let me know... Cheers and thanks... :) -----Original Message----- From: torontocbm-bounce@xxxxxxxxxxxxx [mailto:torontocbm-bounce@xxxxxxxxxxxxx] On Behalf Of Miraglia, Walter Sent: Friday, May 22, 2009 3:47 PM To: torontocbm@xxxxxxxxxxxxx Subject: [torontocbm] Re: does any one know what the correct syntax for opening a .d64 image is on sd2iec? Yup I saw that, but had trouble with it... So I was looking for a straight forward example Using the example of MSPACMAN.D64... So ? would it be: OPEN1,8,15":MSPACMAN.D64":CLOSE1 If so I tried that and got a syntax error...tried many... :) Any time I used OPEN I got a syntax error, which is why I was asking, I'm also trying to determine if I have an issue with my sd2iec... So if anyone can provide an example of what I am to type, it would be very very helpful... Cheers and thanks for the link Golan, :) -----Original Message----- From: torontocbm-bounce@xxxxxxxxxxxxx [mailto:torontocbm-bounce@xxxxxxxxxxxxx] On Behalf Of Golan Klinger Sent: Friday, May 22, 2009 3:31 PM To: torontocbm@xxxxxxxxxxxxx Subject: [torontocbm] Re: does any one know what the correct syntax for opening a .d64 image is on sd2iec? Walter Miraglia wrote: > For example, if I have mspacman.d64 on the root of my sd card in my > > Trusty (remains to be seen) SD2IEC what do I type to get access to it? The answer can be found in the SD2IEC entry at the C64 Wiki: http://www.c64-wiki.com/index.php/sd2iec_%28firmware%29 -- Golan Klinger <gklinger@xxxxxxxxx> Dark is the suede that mows like a harvest.