[PCB_FORUM] Question regarding the netlength.il skill file

Hello once again.

I was trying to test out the netlength.il skill file but when I load the .il file and run the command (det) it gives me the error below.

E- *Error* fprintf: argument #1 should be an I/O port (type template = "ptg") - nil

I have tried running it on both Version 14 and 15 and I have had no luck.  Does anyone else get this error?  Has anyone found solution for this?  Please let me know if anyone has had this problem.

Thank you,

Seiji

---

From: "Soledad Attia" <SAttia@xxxxxxxxxxxxxx>
Reply-To: icu-pcb-forum@xxxxxxxxxxxxx
To: <icu-pcb-forum@xxxxxxxxxxxxx>
Subject: [PCB_FORUM] Re: Is it possible to down rev from version 15-->14-->13?
Date: Wed, 7 Feb 2007 09:04:21 -0800

Hi Seiji

 

You can’t go down a version once is saved using the higher version.

 you will need To keep it at version 13.6.

 

I can’t think of another way to do it

 

Good luck

 

Soledad Attia

 

---

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of arimitsu seiji
Sent: Wednesday, February 07, 2007 8:51 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Is it possible to down rev from version 15-->14-->13?

 

Hi all,

 

It seems like I can’t stop running into trouble these days :) 

 

Lets say I have a customer using Version 13.6 and we no longer have it installed.  I currently have access to Version 14 and 15.  Is it possible to use one of these versions and down rev the data down back to 13.6 after we are done with routing.  We need to keep it at 13.6 for customer purpose.  I thought about just importing and exporting subdrawing but I remember it having some issues in the past and it is a pretty dense board so I'm afraid I might miss something.

 

If anyone have any idea/suggestions please let me know.

 

Thank you,

Seiji

----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to http://www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------

All trademarks and copyrights within the FreeLists archives are owned by their respective owners. Everything else ©2000-2009 Avenir Technologies, LLC. FreeLists is a service of Avenir Technologies, LLC.