As far as I know, X terminals are identified by their IP address. If your terminal gets its address from a DHCP server, you will not be able to use a dedicated display manager. Maybe your pc has a fixed IP address and your WYSE terminal has not. Regards, Ulrich Wieczorek Schouten, Frits JF schrieb: > The same problem here but I cannot, for anything in the world, figure > this one out. > I've now configured dmcfg such that the xterm is no longer using a > dedicated display. > How can I find out how the WYSE 5150 is identifying itself on the > network? > > Cheers, > Frits. > > > -----Original Message----- > From: foxboro-bounce@xxxxxxxxxxxxx [mailto:foxboro-bounce@xxxxxxxxxxxxx] > On Behalf Of Mueller, Jim D. > Sent: Thursday, 10 May 2007 5:41 AM > To: foxboro@xxxxxxxxxxxxx > Subject: [foxboro] WYSE 5150SE > > Gentlemen, > =09I am setting up a WYSE 5150SE terminal to use as an xterminal. > I am able to set up a display manager in the dmcfg file and connect to > it without any Problem. The one strange thing that I am running into is > that I cannot get the WYSE 5150 to connect to a dedicated display > manager. I can use the Same configuration and open a dedicated display > manager using a Exceed session. Although it does not make sense, the > problem only occurs when using A WYSE 5150SE terminal. Has anyone out > there run across this same problem? > > > Thanks for your help in advance! > > James Mueller > Senior Process Control Engineer > Cliffs Michigan Mining Co. > (906) 475-3534 > JDMueller@xxxxxxxxxxxxxxxxxxxx > -- ------------------------------------------- Ulrich Wieczorek Erpicon Software Development GmbH Neusser Str. 724-726 D-50737 Koeln Tel.: +49-221-9746067 Fax: +49-221-9746099 _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave