[softwarelist] OPro 2.76

I've just experienced a repeatable printing error that I have not
come across before.

I was printing a multi-page document using !Printers 1.62 and RO4.39
on a SARPC.

The error is:

"Overflow while transforming point".

I isolated the problem page by trial and error and found that the
error was repeatable (in fact, two consecutive pages gave the same
error). Both had similar embedded graphics - screen-shots of menus.

I saved one of the pages as DDL and when I double-clicked this DDL it
would not load and gave the error 'Unknown object at 116'

I then saved the graphics as Drawfiles and deleted them completely
from the document - which then printed OK.

I then dragged the drawfiles back into the document at the same
places and now it printed OK.

However, I noticed that the size of the re-loaded drawfiles on the
page were now smaller (70% approx) than in the original document
(100%), although there is plenty of space in the frame for them to be
full size. I adjusted them back to 100% and it still printed OK

So, the problem is now removed - but I'd welcome some ideas on what
caused it in the first place.

(BTW, the original document was a conversion from Impression, which
prints both pages OK.)

-- 
Regards from Ray Favre. Email at:  <ray@xxxxxxxxxxxxxx>
  Web site at: <http://www.rayfavre.me.uk/>
  Tel: (+44) (0)1895 444410

Other related posts: