Help??? When I unsolder pin 23 & pin 24 on micro.(U13101) I get real good clock & data pulses coming out, but the DC voltages are low.The DC voltage on the pads is 4.9 volts , but when I reconnect, I only get 1.6 volts on pin 23(data) & 2.29volts on pin 24(clock). The micro seems to be holding the voltage down.I don't have anything coming out of pin 19(run/stby).The micro costs $49.00, and I am trying to make sure it is really bad before I get a new one. I dont see many of projection sets here and won't need a spare micro if this is still good. Any help greatly appreciated Richard La Placa Continental TV 312a Park Row Chestertown, Md. fax&phone-410-778-1113 website: http://www.continentaltv.homestead.com/ continentaltv@xxxxxxxxxxx ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/