rms does I think! From: JACK GARIBALDI Sent: Thursday, October 13, 2011 9:26 PM To: tccrockets@xxxxxxxxxxxxx Subject: [tccrockets] Re: Attn: Brian Dalby CTI does not do 18mm loads Jack G ----- Original Message ----- From: Rob Diehl To: tccrockets@xxxxxxxxxxxxx Sent: Thursday, October 13, 2011 9:24 PM Subject: [tccrockets] Re: Attn: Brian Dalby I thought they were going to do some cti grains in there. I can do sugar but I don't have any casting tubes that size. From: tccrockets-bounce@xxxxxxxxxxxxx [mailto:tccrockets-bounce@xxxxxxxxxxxxx] On Behalf Of Jack Garibaldi Sent: Thursday, October 13, 2011 8:37 PM To: tccrockets@xxxxxxxxxxxxx Subject: [tccrockets] Re: Attn: Brian Dalby Have Rob do some sugar loads for you for testing. Jack G From: tccrockets-bounce@xxxxxxxxxxxxx [mailto:tccrockets-bounce@xxxxxxxxxxxxx] On Behalf Of Rob Diehl Sent: Thursday, October 13, 2011 7:56 PM To: tccrockets@xxxxxxxxxxxxx Subject: [tccrockets] Re: Attn: Brian Dalby Nice! From: tccrockets-bounce@xxxxxxxxxxxxx [mailto:tccrockets-bounce@xxxxxxxxxxxxx] On Behalf Of Chvy91bowtie@xxxxxxx Sent: Thursday, October 13, 2011 9:58 AM To: tccrockets@xxxxxxxxxxxxx Subject: [tccrockets] Attn: Brian Dalby Brian, I finally got around to machining the 18mm hardware we talked about back at DA. Not sure if it will work but I think it looks pretty cool. I will bring a set to October Skies for you. The shiny object in the center is a dime for scale.