Ok cool Brian From: chvy91bowtie@xxxxxxx Sent: Monday, October 17, 2011 9:00 PM To: Rob Diehl ; tccrockets@xxxxxxxxxxxxx Subject: [tccrockets] Re: [tccrockets] Re: Attn: Brian Dalby Well we will need those parts if we pour our own grains. If the aerotech 3 pk works then we will get a bunch of o rings two nozzles two delay grains and ejection charges as a bonus with each flight. I already cut one nozzle in half machining an o ring groove into it there just isn't any meat there for machining. But I still have two so right now I don't need parts. Sent from my HTC on the Now Network from Sprint! ----- Reply message ----- From: "Rob Diehl" <rwdiehl@xxxxxxxxxxxxx> Date: Mon, Oct 17, 2011 8:51 pm Subject: [tccrockets] Re: Attn: Brian Dalby To: <tccrockets@xxxxxxxxxxxxx> Hey Brian. Are you ok? If you are going to order nozzles, etc, I would not wait too long as they may or may not have that stuff ready to ship. Can’t wait to see it at OS. Rob From: tccrockets-bounce@xxxxxxxxxxxxx [mailto:tccrockets-bounce@xxxxxxxxxxxxx] On Behalf Of bkhdalb Sent: Monday, October 17, 2011 12:16 PM To: tccrockets@xxxxxxxxxxxxx Subject: [tccrockets] Re: Attn: Brian Dalby her is the we can get the part for the motor http://www.rocketmotorparts.com/ Brian From: Chvy91bowtie@xxxxxxx Sent: Thursday, October 13, 2011 9:57 AM To: tccrockets@xxxxxxxxxxxxx Subject: [tccrockets] Attn: Brian Dalby Brian, I finally got around to machining the 18mm hardware we talked about back at DA. Not sure if it will work but I think it looks pretty cool. I will bring a set to October Skies for you. The shiny object in the center is a dime for scale. </h