[pure-silver] Re: temp for flattening prints
- From: Shannon Stoney <sstoney@xxxxxxx>
- To: pure-silver@xxxxxxxxxxxxx
- Date: Wed, 19 Apr 2006 08:42:13 -0500
Shannon
I use the same temp as for dry-mounting for 2 minutes between two pieces of
mat-board. Then I take it out and cool it under a heavy piece of glass for 5
minutes. Aluminum may be a better heat conductor, but glass works fine and
is easier to get get and to keep clean.
What is your dry mounting temperature?
--shannon
Regards
Ralph W. Lambrecht
http://www.darkroomagic.com
On 2006-04-19 03:06, "Shannon Stoney" <sstoney@xxxxxxx> wrote:
I think I am going to check the temperature that that dry mount press
I have been using gets to. It doesn't seem to get very hot to me.
But, what is the right temperature for flattening prints?
--shannon
==============================================================================
===============================
To unsubscribe from this list, go to www.freelists.org and logon to your
account (the same e-mail address and password you set-up when you
subscribed,)
and unsubscribe from there.
=============================================================================================================
To unsubscribe from this list, go to www.freelists.org and logon to
your account (the same e-mail address and password you set-up when
you subscribed,) and unsubscribe from there.
=============================================================================================================
To unsubscribe from this list, go to www.freelists.org and logon to your
account (the same e-mail address and password you set-up when you subscribed,)
and unsubscribe from there.
Other related posts:
