On Monday 18 July 2005 13:59, Richard Knoppow wrote: Richard, I was using a fiberglass kit from Home Depot. The mixture hardened very rapidly. I only had about two minutes of working time per batch. The cloth had a tendency to lift up, fold or whatever. I ended up with very sharp edges of fiberglass covered cloth and large "bubbles" of fiberglassed cloth. I'm sure someone more experienced with working with it on a regular basis could have done a much better job. The areas where I just brushed on the fiberglass directly to the wood have a nice glossy appearance. Gary > What problems were caused by the fiberglass cloth? > > --- > Richard Knoppow > Los Angeles, CA, USA > dickburk@xxxxxxxxxxxxx > > > =========================================================================== >================================== To unsubscribe from this list, go to > www.freelists.org and logon to your account (the same e-mail address and > password you set-up when you subscribed,) and unsubscribe from there. ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.