[bookport] Re: beta trouble
- From: "foxtrot" <foxtrot1@xxxxxxxxxxx>
- To: <bookport@xxxxxxxxxxxxx>
- Date: Thu, 10 Jun 2004 17:54:39 -0400
I had the same problem on my 512 Mb card. I removed the 512 card and
inserted the 64 Mb card I had been using previously. The contents are still
on the 64 Mb card. Do I have to reformat this card to make use of the beta
firmware?
Also, how can I reformat the 512 Mb card? I read procedure for correcting
card problem, but I don't have any card reader/write than the bookport.
Thanks for any help.
Rickr----- Original Message -----
From: "Lou Kolb" <loukolb@xxxxxxxxxxx>
To: <bookport@xxxxxxxxxxxxx>
Sent: Thursday, June 10, 2004 5:18 PM
Subject: [bookport] beta trouble
> I finally got around to trying to install the new beta firmware and
software. Actually, I still haven't gotten to the software yet because
since I've installed the firmware the unit will only read the directory over
and over. The only way I can stop this behavior is to remove the batteries.
When I put them back in, it starts all over again. No key or key
combination has any effect except the reset command, 2B. When I hit that,
it says defaults restored book port 1.1 test 7 ready and then continues
looping the directory information. I'm using a win 2k system here at home
but have XP at work. Perhaps I should try it there. Any suggestions would
be appreciated. I'm going through withdrawal without the thing. Lou
>
>
Other related posts:
