[bookport] Re: beta trouble
- From: "ROB MEREDITH" <rmeredith@xxxxxxx>
- To: <bookport@xxxxxxxxxxxxx>
- Date: Fri, 11 Jun 2004 09:19:41 -0400
Dale:
I am interested in what files show in My Computer under drive G. You would =
have to make Windows Explorer show hidden files to see them all. If there =
are any, zipping them up and sending them may be helpful.
>>> drlieser@xxxxxxx 06/11/04 09:00AM >>>
Rob:
No, I am not Lou!<smile>
My babbling card shows to have nothing on it, according to the transfer
software. So there'd be nothing to zip up and send to you.
In "my computer", the BP is listed as hard drive G.
I don't know whether these tidbits will help in any way, but neither could
they hurt.
Dale
----- Original Message -----=20
From: "ROB MEREDITH" <rmeredith@xxxxxxx>
To: <bookport@xxxxxxxxxxxxx>
Sent: Friday, June 11, 2004 7:41 AM
Subject: [bookport] Re: beta trouble
> Lou:
>
> Are you able to connect with the PC? Does Book Port Transfer start when =
=3D
> you connect? Does the Book Port show up as a drive?
>
> Rob Meredith
>
> >>> loukolb@xxxxxxxxxxx 06/10/04 05:18PM >>>
> I finally got around to trying to install the new beta firmware and =3D
> software. Actually, I still haven't gotten to the software yet because =
=3D
> since I've installed the firmware the unit will only read the directory =
=3D
> over and over. The only way I can stop this behavior is to remove the =
=3D
> batteries. When I put them back in, it starts all over again. No key =
or
=3D
> key combination has any effect except the reset command, 2B. When I hit =
=3D
> that, it says defaults restored book port 1.1 test 7 ready and then =3D
> continues looping the directory information. I'm using a win 2k system =
=3D
> here at home but have XP at work. Perhaps I should try it there. Any =
=3D
> suggestions would be appreciated. I'm going through withdrawal without =
=3D
> the thing. Lou
>
>
>
Other related posts:
