Hi David, I see you have gotten quite a few responses to your question. Is the problem solve yet? I have had great success with metallic on hats using WACF. But before I go through the time of explanation.............just = need to know if you are still in need of a solution? Also, are you on an XT or an older version Amaya? Karen Peachey Threads -----Original Message----- From: amayausers-bounce@xxxxxxxxxxxxx [mailto:amayausers-bounce@xxxxxxxxxxxxx] On Behalf Of dsklar@xxxxxxxxxxx Sent: Wednesday, May 24, 2006 8:26 AM To: amayausers@xxxxxxxxxxxxx Subject: [amayausers] Metallic Thread I recently had a job with 8 caps (unstructured), polos, tees, and = sweats. All used the same logo. Parts of the logo were stitched using metallic thread. Everything went fine except for the hats. It took several = hours to get the hats done. There was a thread break every few rows. It seemed = to make no difference whether it was stitching the underlay (density irrelevent) or the actual fill. The polos, tees sweats sewed without problem using a 75/11BP. For the unstructured caps I used two layers of medium tearaway backing. I started with a 75/11 sharp went up to 80/12 sharp (don't have bigger), changed needles (to new ones and location on = the machine), but could not make any difference. The problem area is not on = or near a seam. I played with the material thickness as well. The cap was = on a WACF. I have done plenty of caps. I have done some metallic before. = But this is the first metallic on caps. Any thoughts on what the problem = was? Thanks. David Sklar Ballyhoo! Arlington, VA=20 =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D= =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D= =3D=3D=3D=3D=3D=3D=3D=3D=3D=20 The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D= =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D= =3D=3D=3D=3D=3D=3D=3D=3D=3D=20 =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================