This message was posted by thepreppyone on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/2/1619.html I'm very frustrated....my design has sewn out fine many time then it decided to ball up underneath....The metallic thread just catches and then turns into a ball down by the bobbin then I can't cut it without cutting the fabric....I've lost more shirts than I've done...anybody had any luck...I slowed the setting down to 750 stitch speed....set material feed anywhere from 3 to 9 and nothing helps...it doesn't get stuck in the same place each time either....HELP I have 50 of these =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================