Dana, What's a toque? Mike Ram Printing and Promotions Inc wrote: >cut the top off a small toque and then pop over the top of the bill prior to >embroidery. This rubs on the toque and not the frame > >Dana @ >Ram Printing & Promotions Inc. >(780) 875-5073 >www.ramprinting.net > >----- Original Message ----- >From: Tracy Neighbors <EnchantThreads@xxxxxxx> >Date: Friday, May 12, 2006 8:03 am >Subject: [amayausers] Re: Marks on Ballcap bills > > > >>-----Original Message----- >>From: amayausers-bounce@xxxxxxxxxxxxx >>[mailto:amayausers-bounce@xxxxxxxxxxxxx] On Behalf Of Laughing Palm >>Inc.Sent: Friday, May 12, 2006 7:56 AM >>To: amayausers@xxxxxxxxxxxxx >>Subject: [amayausers] Marks on Ballcap bills >> >>I am curious if others are experiencing the same issue I'm coming >>acrosswith ballcaps... >> >>When I use one of the cap frames (doesn't matter if it's the wide >>angle or >>standard frame), the back side of the needle case frame rubs >>against the >>center of the cap bills and produces a subtle, but noticeable, >>horizontalmark. Since I tend to >> >> > avoid doing ballcaps, this isn't a > > >>major issue for >>me, but I'd like to know if this is a normal, or is there some kind of >>adjustment I can make to avoid having that metal bar rub against >>the ballcap >>bills. I tried putting some material between the bill and the bar, >>but it >>didn't help very much. >> >>Any suggestions? >> >>Jim Sulsona >>Laughing Palm, Inc. >>Custom Embroidered & Screen Printed Products Post Office Box 957073 >>Duluth,GA 30095-9518 USA Toll Free: 1-877-4EMBROIDERY >>Tel: 770-448-1171 >>Fax: 770-417-1457 >>sales@xxxxxxxxxxxxxxxx >>www.laughingpalm.com <http://www.laughingpalm.com/> >> >> >> >> >> >> >> > > > > >