cut the top off a small toque and then pop over the top of the bill prior to embroidery. This rubs on the toque and not the frame Dana @ Ram Printing & Promotions Inc. (780) 875-5073 www.ramprinting.net ----- Original Message ----- From: Tracy Neighbors <EnchantThreads@xxxxxxx> Date: Friday, May 12, 2006 8:03 am Subject: [amayausers] Re: Marks on Ballcap bills > > > -----Original Message----- > From: amayausers-bounce@xxxxxxxxxxxxx > [mailto:amayausers-bounce@xxxxxxxxxxxxx] On Behalf Of Laughing Palm > Inc.Sent: Friday, May 12, 2006 7:56 AM > To: amayausers@xxxxxxxxxxxxx > Subject: [amayausers] Marks on Ballcap bills > > I am curious if others are experiencing the same issue I'm coming > acrosswith ballcaps... > > When I use one of the cap frames (doesn't matter if it's the wide > angle or > standard frame), the back side of the needle case frame rubs > against the > center of the cap bills and produces a subtle, but noticeable, > horizontalmark. Since I tend to avoid doing ballcaps, this isn't a > major issue for > me, but I'd like to know if this is a normal, or is there some kind of > adjustment I can make to avoid having that metal bar rub against > the ballcap > bills. I tried putting some material between the bill and the bar, > but it > didn't help very much. > > Any suggestions? > > Jim Sulsona > Laughing Palm, Inc. > Custom Embroidered & Screen Printed Products Post Office Box 957073 > Duluth,GA 30095-9518 USA Toll Free: 1-877-4EMBROIDERY > Tel: 770-448-1171 > Fax: 770-417-1457 > sales@xxxxxxxxxxxxxxxx > www.laughingpalm.com <http://www.laughingpalm.com/> > > > > >