Try normalizing the track in Studio recorder. Some microphones have a
higher output than others and will record at a higher volume naturally.
-----Original Message-----
From: studiorecorder-bounce@xxxxxxxxxxxxx
[mailto:studiorecorder-bounce@xxxxxxxxxxxxx] On Behalf Of Larry
Sent: Thursday, August 4, 2016 9:50 AM
To: studiorecorder@xxxxxxxxxxxxx
Subject: [studiorecorder] Re: Accessible Disk burning and CD copying
software
Mary,
I also use Windows 7. I followed your suggestion and everything is set to
100%, but still not able to produce a strong volume when using Studio
Recorder. I have tried switching microphones and get the same result.
Baffled.
Larry
-----Original Message-----
From: studiorecorder-bounce@xxxxxxxxxxxxx
[mailto:studiorecorder-bounce@xxxxxxxxxxxxx] On Behalf Of Mary Emerson
(Redacted sender "maryemerson" for DMARC)
Sent: Thursday, August 04, 2016 5:39 AM
To: studiorecorder@xxxxxxxxxxxxx
Subject: [studiorecorder] Re: Accessible Disk burning and CD copying
software
Larry,
I don't know which operating system you're using; I use Windows 7. Other
operating systems probably have similar controls; I don't have a Mac so
can't help you with that. In Windows 7 there is a built-in mixer that is
accessible via the system tray. Once you get into the system tray, arrow
down to "speaker" if you're using Windows 7; press enter; you're on "open
volume mixer." Press enter. Tab around and you'll find separate volume
controls for the microphone and all software that has audio output of some
type. These controls are sliders; usually page-up increases the volume. When
you're done, alt-f4 to exit.
Mary
