i would like to ty for ur help with this.now i have 2 questions the frist one is on this 50001 ps2 when it came in the shop it would only play ps1 disk so i replaced the lasre with a know good laser and it would start to play the disk then after it but the frist screens it would go into a no read erroe.so i think it may be the tray aliment but not sure.i should tell u i have been in the repair feild since 1971 and have just started doing these and x-box's and game cubes.since i became disable i can no long do tv's so i went this route.qusetion 2 i have an x-box i think it's 1.4 it has a bad hard drive is there a way of just replacing the drive with out moding it.the cust dose not want it moded just the hard drive i was told if i replace the eeprom it would do the trick but not to sure it will. thank you once again for an help u can give us as i am new in gamesystems chuck staples ps forgive the spelling my spell chcker is down and i didn't know it till i try to use it just now sorry ----- Original Message ----- From: "Customer Support - Powerfulguides.com" <cs@xxxxxxxxxxxxxxxxxx> To: "staples tv" <hivolts@xxxxxxxxxxxxxxxx> Sent: Monday, April 18, 2005 7:02 PM Subject: Re: PS 2 > Adjust them the same way as you do the one wheel on earlier versions. Just > adjust both wheels at the same time. If you turn one wheel 2 clicks then do > the same to the other. There is a hole in each wheel so if you are not sure > they are both aligned you can adjust the wheels until you see the hole in > each. this will make sure both wheels are exactly in the same position. > let me know if you have any other questions. > Sincerely, > Mark Eastman > Powerful Guides > www.powerfulguides.com ----- Original Message ----- From: "Customer Support - Powerfulguides.com" <cs@xxxxxxxxxxxxxxxxxx> To: "staples tv" <hivolts@xxxxxxxxxxxxxxxx> Sent: Monday, April 18, 2005 7:02 PM Subject: Re: PS 2 > Adjust them the same way as you do the one wheel on earlier versions. Just > adjust both wheels at the same time. If you turn one wheel 2 clicks then do > the same to the other. There is a hole in each wheel so if you are not sure > they are both aligned you can adjust the wheels until you see the hole in > each. this will make sure both wheels are exactly in the same position. > let me know if you have any other questions. > Sincerely, > Mark Eastman > Powerful Guides > www.powerfulguides.com > ----- Original Message ----- > From: "staples tv" <hivolts@xxxxxxxxxxxxxxxx> > To: <cs@xxxxxxxxxxxxxxxxxx> > Sent: Monday, April 18, 2005 7:15 PM > Subject: PS 2 > > > > Below is the result of your feedback form. It was submitted by > > staples tv (hivolts@xxxxxxxxxxxxxxxx) on Monday, April 18, 2005 at > > 18:15:42 > > -------------------------------------------------------------------------- - > > > > body: dear mark > > i bought ur ps2 repair book but i have a model 50001.that is not covered > > but ur book.i need to know how to aline the two gears in the rear of the > > laser assy.it will read ps1 disk so i change the laser assy and it will > > start to read ps2 disk then go into a no read error.it will do the same > > with dvd's will get pass the fbi warning the go into no read error > > thank you > > chuck staples > > ----- Original Message ----- From: "Al L" <alleathe@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, April 19, 2005 11:49 AM Subject: [TechAssist] Re: RCA PTK195M2T tube isolation > Could you isolate it the same way we do Sonys?Windings on the fly core? > > Al Leatherman > 224 RT. 46 > Mine Hill, NJ 07803 > 973-361-5796 > WWW.ALS-TV.NET > > ----- Original Message ----- > From: "markbrock" <markbrock@xxxxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Tuesday, April 19, 2005 8:59 AM > Subject: [TechAssist] RCA PTK195M2T tube isolation > > > > any one isolated the screen or what ever on these tubes ? this one has > > bright blue with retrace, real nice picture when they brought it in, > > played for couple days, now all blue, need a salvage gun or advise on how > > to isolate the short model is P61927 > > thanks for all help and advise > > brock > > > > Brock Electronics > > R.R.4 box 237 > > 5208 cr.3385 > > Independence Ks. 67301 > > 620-331-0235 > > fax 331-7191 > > > > markbrock@xxxxxxxxxxxxx > > Zenith*Philips*Peavey*Fender*Crate > > we work on all brands,makes,models > > of anything that plugs in the wall > > > > -------------------------------------------------------------------------- --- > > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > > Lost Password: http://www.tech-assist.org and select "Login Problems?". > > Appliance Repair List: > > http://www.tech-assist.org/secure/tip/chatjoin.htm#app > > Email Archives: //www.freelists.org/archives/techassist/ > > > > > -------------------------------------------------------------------------- --- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app > Email Archives: //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/