Al There may be to much material to grind of the table I think I will have to dismantle it to find the offending part and work from there. Lee ----- Original Message ----- From: "Allen Messer" <al_messer@xxxxxxxxx> To: <modeleng@xxxxxxxxxxxxx> Sent: Monday, October 04, 2004 12:21 AM Subject: [modeleng] Re: Mico Mill Problems > Lee, is the top of thetable out this much in all > positions; at each end? It may be that you'll have to > have the top of the table trued up on a surface > grinder if it is out all over. > > Al Messer > --- Lee Grant <leegrant@xxxxxxxxxx> wrote: > > > I finally managed to spend some quality time in the > > workshop this weekend > > set up the face plate and bored the two cylinders of > > the marine piston valve > > engine I am building. Because of a lack of swing on > > my small lathe I couldn' > > t bore the two piston valve cylinders so I had to > > drill them on my Micro > > Mill. The two bored cylinders turned out almost > > perfect + or - 001" nice > > finish the two drilled holes looked ok until I > > turned it over the holes came > > out 4mm of centre, a check with a 6" square on the > > mill table to the column > > found that the column is tilting forward I can fit a > > 015" feeler gage at the > > bottom of the square. This may be part of the reason > > for the mills poor > > performance. The column can tilt 45 degrees side to > > side on a pivot and is > > bolted to the base with 4 cap head bolts I could > > shim it temporally for a > > quick fix but I think I need to dismantle it and > > have it machined correctly > > This will probably make an expensive mill out of a > > cheap one. Are there any > > better ideas out there? > > > > Lee > > > > MODEL ENGINEERING DISCUSSION LIST. > > > > To UNSUBSCRIBE from this list, send a blank email > > to, > > modeleng-request@xxxxxxxxxxxxx with the word > > "unsubscribe" in the subject line. > > > > > > > _______________________________ > Do you Yahoo!? > Declare Yourself - Register online to vote today! > http://vote.yahoo.com > MODEL ENGINEERING DISCUSSION LIST. > > To UNSUBSCRIBE from this list, send a blank email to, > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line. > MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.