Hey guys,
Anyone out there modify their drill chart
file (“default-mil.dlt” for mils)?
I have a “CustomData” section
where the hole size, Plated or Non-plated and the tolerance is listed.
With Allegro now defining slots, I can’t
figure out how to get a slot tolerance to show up in the drill chart.
Here’s the line in the “CustomData”
section for the slot that’s not working correctly:
(85.0 x 40.0 "Plated" "+/-
4.0")
The size and the word “Plated”
shows up in the drill chart, but not the tolerance (+/- 4.0).
Any ideas?
Thanks,
Gary
Gary E. MacIndoe
PCB Design
Engineer
Fort Collins, Colorado
amd.com