Problem 1: Your hole size is incorrectly specified. You need to have (85.0 40.0) instead of 85.0 x 40.0. Problem 2: You need to enter ALL the text, not just the tolerance The modified line would look line ((85.0 40.0) "Plated" "85.0 X 40.0 +/- 4 MIL") or whatever. This is a SKILL thing, parentheses inside parenthesis. Make sure you have a user field specified in your column definitions, we use (("Figure" "FIGURE" 6) ("Holesize" "BIT DIA" 8) ("User" "FINISHED HOLE" 24 "Left") ("Quantity" "QTY" 6 "Right")) -- George Patrick Tektronix, Inc. Central Engineering, EDS Applications Support P.O. Box 500, M/S 39-512 Beaverton, OR 97077-0001 * 503-627-5272 (voice) * 503-627-5587 (fax) <http://www.tektronix.com/> http://www.tektronix.com <http://www.pcb-designer.com/> http://www.pcb-designer.com "Off-Grid and Proud of it!" -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Macindoe, Gary Sent: Thursday, January 10, 2008 12:33 To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] default-x.dlt file snafu Hey guys, Anyone out there modify their drill chart file ("default-mil.dlt" for mils)? I have a "CustomData" section where the hole size, Plated or Non-plated and the tolerance is listed. With Allegro now defining slots, I can't figure out how to get a slot tolerance to show up in the drill chart. Here's the line in the "CustomData" section for the slot that's not working correctly: (85.0 x 40.0 "Plated" "+/- 4.0") The size and the word "Plated" shows up in the drill chart, but not the tolerance (+/- 4.0). Any ideas? Thanks, Gary Gary E. MacIndoe PCB Design Engineer Fort Collins, Colorado amd.com gary.macindoe@xxxxxxx