Thanks George, but it's just not working. When I change to "85.0 40.0", I get the error message: E- *Error* lowerCase: argument #1 should be either a string or a symbol (type template = "S") - 40.0 BTW, I have the first "(" up above, and the last ")" below the line for the slot. So when my line reads "(85.0 x 40.0) "Plated" "85.0 x 40.0 +/- 4.0")", error message: E- *Error* length: argument must be a list or an array - "Plated" Yes, I have a user field specified in the column definitions: ("User" "TOLERANCE" 10) My drill chart has Figure, Size, Tolerance, Plated and Qty columns and works great except for the slot. It will not plug in the tolerance for the slot, but will for all of the plated and non-plated holes. Thanks for your time, when I have time I'll contact support. Gary Gary E. MacIndoe PCB Design Engineer Fort Collins, Colorado amd.com gary.macindoe@xxxxxxx ________________________________ From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of george.h.patrick@xxxxxxxxxxxxx Sent: Thursday, January 10, 2008 1:57 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: default-x.dlt file snafu Problem 1: Your hole size is incorrectly specified. You need to have (85.0 40.0) instead of 85.0 x 40.0. Problem 2: You need to enter ALL the text, not just the tolerance The modified line would look line ((85.0 40.0) "Plated" "85.0 X 40.0 +/- 4 MIL") or whatever. This is a SKILL thing, parentheses inside parenthesis. Make sure you have a user field specified in your column definitions, we use (("Figure" "FIGURE" 6) ("Holesize" "BIT DIA" 8) ("User" "FINISHED HOLE" 24 "Left") ("Quantity" "QTY" 6 "Right")) -- George Patrick Tektronix, Inc. Central Engineering, EDS Applications Support P.O. Box 500, M/S 39-512 Beaverton, OR 97077-0001 * 503-627-5272 (voice) * 503-627-5587 (fax) http://www.tektronix.com <http://www.tektronix.com/> http://www.pcb-designer.com <http://www.pcb-designer.com/> "Off-Grid and Proud of it!" -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Macindoe, Gary Sent: Thursday, January 10, 2008 12:33 To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] default-x.dlt file snafu Hey guys, Anyone out there modify their drill chart file ("default-mil.dlt" for mils)? I have a "CustomData" section where the hole size, Plated or Non-plated and the tolerance is listed. With Allegro now defining slots, I can't figure out how to get a slot tolerance to show up in the drill chart. Here's the line in the "CustomData" section for the slot that's not working correctly: (85.0 x 40.0 "Plated" "+/- 4.0") The size and the word "Plated" shows up in the drill chart, but not the tolerance (+/- 4.0). Any ideas? Thanks, Gary Gary E. MacIndoe PCB Design Engineer Fort Collins, Colorado amd.com gary.macindoe@xxxxxxx