Hey guys, Anyone out there modify their drill chart file ("default-mil.dlt" for mils)? I have a "CustomData" section where the hole size, Plated or Non-plated and the tolerance is listed. With Allegro now defining slots, I can't figure out how to get a slot tolerance to show up in the drill chart. Here's the line in the "CustomData" section for the slot that's not working correctly: (85.0 x 40.0 "Plated" "+/- 4.0") The size and the word "Plated" shows up in the drill chart, but not the tolerance (+/- 4.0). Any ideas? Thanks, Gary Gary E. MacIndoe PCB Design Engineer Fort Collins, Colorado amd.com gary.macindoe@xxxxxxx