Gary, Attempting to define a single layer padstack per your 2nd option ... Pad_Designer only allows features on "BEGIN LAYER" for a Type Single padstack - do I need to define the pad as a Type Through and only define pad shapes on "END LAYER" and "SOLDERMASK BOTTOM"? Thanks, Dave > > From: "Macindoe, Gary" <Gary.Macindoe@xxxxxxx> > Date: 2008/01/25 Fri AM 09:54:14 CST > To: icu-pcb-forum@xxxxxxxxxxxxx > Subject: [PCB_FORUM] Re: Bottom Side SMT Testpad Definition > > Dave Schaefer dave.schaefer@xxxxxxx
Hey Dave, Wow, I can't believe no one responded to this. I typically don't have to worry about testprep (yes it's nice!), but can't you just mirror the test via to the bottom? I can't remember, it's been too long, but just mirroring it might work. Anyway, creating a padstack to default to the bottom is really easy. Define your bottom TP for the "END LAYER" and "SOLDERMASK_BOTTOM" only (no paste!). Here is an example of a padstack used for the bottom of an edge connector: In your TP symbol, define Bottom Assembly, Bottom ref des etc. Good luck! Gary E. MacIndoe PCB Design Engineer Fort Collins, Colorado amd.com gary.macindoe@xxxxxxxxxxxxxxxxxxxx Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Dave Schaefer Sent: Thursday, January 24, 2008 2:43 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Bottom Side SMT Testpad Definition I've defined a via for use as a testpoint "TP40SP" which is a .040" square pad (smt / surface layer only). When I bring this via into a design, it defaults to the Top side, and cannot be used as a Bottom Side Tespoint in testprep. How do I define a bottom side SMT (single layer) testpoint "via" padstack? Dave Schaefer dave.schaefer@xxxxxxx ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------