[duxuser] Re: embosser puts dots at top of braille page when embossing
- From: "John Sanders" <starmy22@xxxxxxxxxxx>
- To: <duxuser@xxxxxxxxxxxxx>
- Date: Tue, 1 Jun 2004 17:20:42 -0400
MessageHi, ok I'll try that.
I have a question: do you hold down all three keys while you turn on the
Braille blazer?
Sincerely,
John Sanders
----- Original Message -----
From: Susan Stageberg
To: duxuser@xxxxxxxxxxxxx
Sent: Tuesday, June 01, 2004 5:16 PM
Subject: [duxuser] Re: embosser puts dots at top of braille page when
embossing
John, I have seen this problem when embossing from a Braille Lite to the
Blazer with no network involved, so it must not always be a problem in the
bios. I believe that George is correct, but there must be other times when this
thing with the extra characters happens, because the same Blazer that put extra
dots on things from the Braille Lite never did it from the computer using
Duxbury. So try a reset; it couldn't hurt.
Susie Stageberg
Project ASSIST with Windows
Iowa Department for the Blind
(515) 281-1351
-----Original Message-----
From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On
Behalf Of John Sanders
Sent: Tuesday, June 01, 2004 4:09 PM
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser] Re: embosser puts dots at top of braille page when
embossing
Hi, if I change my settings on my computer, we are connected up to a local
area network. And, it'll effect all of the other computers on the network.
This is a problem.
How should I go about fixing this?
Sincerely,
John sanders
Other related posts:
