Hi, How come you could not do control-backslash? I can do it here. Just make sure K1000.set is associated when K1000 is loaded. All the best Steve -- Computer Room Services 77 Exeter Close Stevenage Hertfordshire SG1 4PW Tel: +44(0)1438-742286 Mob: +44(0)7956-334938 Fax: +44(0)1438-759589 Email: steve@xxxxxxxxxxxxxx Web: http://www.comproom.co.uk -----Original Message----- From: access-uk@xxxxxxxxxxxxx [mailto:access-uk@xxxxxxxxxxxxx] On Behalf Of Pele West Sent: 14 December 2014 11:51 To: access-uk@xxxxxxxxxxxxx Subject: [access-uk] Re: Views on Window-Eyes 9 Beta 2 Hi Steve Thanks again. I have K1000.set loaded. At least, I think I do. I could not do Control Backslash when in Kurzweil, but I have looked at the list of .set files. Pele ** To leave the list, click on the immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** access-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq ** To leave the list, click on the immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** access-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq