At 11:56 AM 9/8/2003, you wrote: >In a message dated 9/8/03 12:42:28 PM Eastern Daylight Time, >carnealr@xxxxxxxxxxxx writes: > > > What I did was go to Office Depot and pick up a box of Video Tape labels. > > It is wasteful on my part- I only used the long spine label. > > > > Then using Word, I just pulled up that label and typed whatever, but > forced > > it to stay on the ends. > > Example: > > _____________________________________________ > > | Monitor......................................................Monitor| > > | One................................................................One| > > |Power...........................................................Power| > > > ----------------------------------------------------------------------------- > > - > > > > When folded over a cable/cord, it is very readable no matter which "side" > > you read. If you pre-make the labels, the project will go easier. I made > > three labels for every cord. One went on the ends, and one > approximately in > > the center to keep me from have to trace a cord all the way to its end. > > > > Robert > > > > > > > >Wouldn't the small sized mailing label serve the same purpose as less cost? > >MJH Yes, I am positive it would. My goal was to read the labels without having to get under the desk, though, so the extra room on the label to print/read was nice. Robert To unsub or change your email settings: //www.freelists.org/webpage/pctechtalk To access our Archives: http://groups.yahoo.com/group/PCTechTalk/messages/ //www.freelists.org/archives/pctechtalk/ For more info: //www.freelists.org/cgi-bin/list?list_id=pctechtalk