Roger There was a recent article in AME on building a 1 1/2 Allchin The only mention of the injector was that it was purchased from Reeves and he has never been able to get it to work. Lee ----- Original Message ----- From: "Roger" <roger.g3tdm@xxxxxxxxxx> To: <modeleng@xxxxxxxxxxxxx> Sent: Thursday, December 09, 2004 9:00 PM Subject: [modeleng] Re: Injectors - asking the question again > Hi, > > Whilst on the subject of injectors, some of you will know that I am > trying to finish off an Allchin traction engine in 1-1/2" to the foot scale. > > I have got round to piping the various steam valves to their > appropriate destinations. One of them goes to the injector. To my > surprise the original articles (I have them all bound together as a > builder's manual) has no mention of the injector, other than to show > you where it is located. > > Anyone know what sort of size injector is used on this model > engine. Anyone have references to a design of a suitable size that > works with steam pressure up to about 80 psi? > > Thanks in advance. > > > Cheers, > > > Roger Mason, in St. Agnes. > > MODEL ENGINEERING DISCUSSION LIST. > > To UNSUBSCRIBE from this list, send a blank email to, > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line. > > MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.