[PCB_FORUM] Re: How to change an existing cline to a new net???
- From: "Gene Carman" <gcarman@xxxxxxxxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Thu, 26 May 2005 11:08:52 -0700
No, when I try to attach it in any way it either jumps out of the way. GRIN
Or If I do force it to go to a pin, I get DRC errors.
This seems like such a simple thing, yet I cannot find a way to do it. Change
and Edit do not seem to cover it.
It would even be easy to group grab the whole thing and then do a "change," but
I do not see any change command to cover this. I can change width, or layer
(subclass) but not net. I can change the nets of shapes... but not clines. Is
this right?
-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of Eric Hufstedler
Sent: Thursday, May 26, 2005 11:01 AM
To: 'icu-pcb-forum@xxxxxxxxxxxxx'
Subject: [PCB_FORUM] Re: How to change an existing cline to a new net???
As a workaround, can you just connect it to a part with the proper net? It
might matter where you start (the cline or the part).
Either way, it would be good to know if there is a "change" command that would
allow such a change.
eric
-----Original Message-----
From: Gene Carman [mailto:gcarman@xxxxxxxxxxxxxxx]
Sent: Thursday, May 26, 2005 10:55 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] How to change an existing cline to a new net???
I have a trace (cline) that exists in a design that after a logic import
(loaded new netlist) the trace reverted to ground. I want to use that existing
route.
Is there a way to change a particular cline to a new net? The net does exist
in the design... I am just trying to avoid ripping up the trace and basically
following it again. I intentionally did not rip it up when I imported the new
net, just for this reason.
Other related posts:
