[PCB_FORUM] Re: How to change an existing cline to a new net???

import export Excel for CMHi Gene:

 Do you have access to  a Specctra   (Allegro auto router)?

  If you have and REPLY  that you "do":

 I will provide  an outline of how to use Specctra as an "Engineering Change
Order"
"applier"  that ignores the old set of nets and applies the new set to the
existing connectivity.


Hugh Allen
Specctra Specialist
CopperCad Design Inc.
www.coppercad.com
hugh@xxxxxxxxxxxxx



  -----Original Message-----
  From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of Gene Carman
  Sent: Thursday, May 26, 2005 1:55 PM
  To: icu-pcb-forum@xxxxxxxxxxxxx
  Subject: [PCB_FORUM] How to change an existing cline to a new net???



     I have a trace (cline) that exists in a design that after a logic
import (loaded new netlist) the trace reverted to ground.  I want to use
that existing route.

    Is there a way to change a particular cline to a new net?   The net does
exist in the design... I am just trying to avoid ripping up the trace and
basically following it again.  I intentionally did not rip it up when I
imported the new net, just for this reason.

Other related posts: