[PCB_FORUM] Re: How to change an existing cline to a new net???

As a workaround, can you just connect it to a part with the proper net?  It
might matter where you start (the cline or the part).
 
Either way, it would be good to know if there is a "change" command that
would allow such a change.
 
eric
 
 -----Original Message-----
From: Gene Carman [mailto:gcarman@xxxxxxxxxxxxxxx]
Sent: Thursday, May 26, 2005 10:55 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] How to change an existing cline to a new net???



 

 I have a trace (cline) that exists in a design that after a logic import
(loaded new netlist) the trace reverted to ground.  I want to use that
existing route.  
 
Is there a way to change a particular cline to a new net?   The net does
exist in the design... I am just trying to avoid ripping up the trace and
basically following it again.  I intentionally did not rip it up when I
imported the new net, just for this reason.

Other related posts: