[PCB_FORUM] Re: Help!!! Segment with same start and end points
- From: "Van Huynh (huynh)" <huynh@xxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Mon, 20 Dec 2004 08:22:19 -0800
By reduce the drawing accuracy to 2, it's solved my artwork warning
problems.
Van Huynh
-----Original Message-----
From: Ron Dallas [mailto:ron.dallas@xxxxxxxxxxxx]
Sent: Monday, December 20, 2004 6:34 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Help!!! Segment with same start and end points
If you are creating the artwork at a lower resolution than the board
database, the round off can cause the ends of very short segments to end up
at the same co-ordinate.
If you zoom way in at the specified point you might see the segment. If not,
try unfilled lines. Or try using a window with the find filter while zooomed
in. You might find 3 line segments where you expect to find 2.
--
Ron Dallas
Design Technology Group, Teradyne, Inc.
ph: 617-422-2585 fax: 617-422-2801
e-mail: ron.dallas@xxxxxxxxxxxx
-----------------------------------------------------------
To subscribe/unsubscribe:
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe
To view the archives of this list please login at
//www.freelists.org. Our list name is icu-pcb-forum
or go to //www.freelists.org/archives/icu-pcb-forum/
Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
Want to post a job listing ? DON'T DO IT HERE!
Better yet, join our jobs listing forum.
SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx
POST: icu-jobs-forum@xxxxxxxxxx
-----------------------------------------------------------
Other related posts:
